Description
This is an Ametek replacement vacuum motor for your NuTone VX1000, 240 volt.
It has more than a 1/2″ taper at the bottom.
Some earlier models used 2 vacuum motors so check prior to ordering as it is always a good idea to change both at the same time.
For our standard motor gasket, see our part #MTR512.
Uses motor brushes part #MTR551.
CARBON BRUSHES ABOVE WILL NOT FIT THE ORIGINAL NUTONE MOTOR THAT COMES IN THE VX1000. THESE BRUSHES WILL ONLY FIT THE AMETEK VERSION OF THE ORIGINAL MOTOR.
ALSO, PLEASE NOTE THAT THE EXISTING EXHAUST TUBE DOES NOT COME WITH THE AMETEK MOTOR. YOU WILL NEED TO REMOVE THE EXISTING TUBE FROM THE MOTOR AND INSTALL IT ON THE NEW ONE.
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
Reviews
There are no reviews yet.