Description
This is an Ametek Vacuum Motor for your Eureka Boss models CV918, CV918A, CV918B, CV918D, CV1001 Type A, CV1801, CV1801A, CV1801B, CV1801D, CV1801G, CV1801H, CV1810, CV1810A, CV1810B, CV1810D, CV1810G, CV1820, 120 volt.
This motor has sealed bearings in it so dust and dirt will not get into the system. This allows for a longer motor life. The factory motor does not have this sealed bearing.
It is suggested you replace the motor gasket part #MTR512.
Protect your motors from dust and dirt by using a motor filter. This prolongs the life of your motor and is a must for all motors. See our part #MTR553.
Uses motor brush part MTR515.
Installation note:
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
Reviews
There are no reviews yet.