New Lamb Ametek 116671-50 motor is 2-stage, 5.7 inch, 120 volt.
It is suggested you replace the motor gasket part #MTR512.
Protect your motors from dust and dirt by using a motor filter. This prolongs the life of your motor and is a must for all motors. See our part #MTR553.
Uses motor brushes part #MTR514.
- Motor Type: Thru Flow
- Discharge: Peripheral
- Bearings: Ball Bearing/Sleeve
- Sealed Vacuum: 100 inches
- Maximum Air Watts: 321
- Maximum Air Flow: 104 CFM
- Maximum Amps: 9.0
- Motor Speed: 20,400 RPM
This is a special order motor.
Over-tightening of the mounting screws may cause the fan casing to push into the fan blades and may damage the fans. This situation is not covered under the Motor Warranty Program and will not be approved if submitted. If motor is turned in under warranty and is found to have the type of damage explained above, the warranty will be denied. When mounting your new motor, in most cases a touch BEYOND “finger tight” is all that is required to mount and seat the motor sufficiently.
There are no reviews yet.